Drill presses: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 12: | Line 12: | ||
[[Category:Projects]] | [[Category:Projects]] | ||
[[Category:Manufacturing]] | [[Category:Manufacturing]] | ||
=Introduction= | |||
=Challenges= | =Challenges= | ||
=Approaches= | =Approaches= | ||
=Interoperability= | =Interoperability= | ||
Line 26: | Line 25: | ||
* Completion of the printable 1kW motor will allow for the power generating portions of the drill press to be copied | * Completion of the printable 1kW motor will allow for the power generating portions of the drill press to be copied | ||
* Lost plastic casting, or direct metal printing will allow for a metalic version of the printable chuck. | * Lost plastic casting, or direct metal printing will allow for a metalic version of the printable chuck. | ||
=References= | |||
* [File:TOOL_DrillPress.pdf] |
Revision as of 01:04, 21 May 2021
Project: Drill presses
Tools: | Wrenches |
---|---|
Parts: | Frames, Nuts, Bolts, Plates, End caps, Linear bearings, Motors |
Techniques: | Shelf joints, Tri joints |
Introduction
Challenges
Approaches
Interoperability
Development targets
- Completion of the replimat linear bearing will allow for the construction of a linear motion system for the press mechanism
- Completion of the printable 1kW motor will allow for the power generating portions of the drill press to be copied
- Lost plastic casting, or direct metal printing will allow for a metalic version of the printable chuck.
References
- [File:TOOL_DrillPress.pdf]