Odd parts first: Difference between revisions
From
| (One intermediate revision by the same user not shown) | |||
| Line 22: | Line 22: | ||
=Challenges= | =Challenges= | ||
Unique parts may not have easy mounting points or compatible hole patterns. Adapting them to the | Unique parts may not have easy mounting points or compatible hole patterns. Adapting them to the [[grids]] can be a challenge. | ||
=Approaches= | =Approaches= | ||
* offset a frame with stacked washers to match an existing hole pattern | * offset a frame with stacked washers to match an existing hole pattern | ||
* drill holes matching your unique mounting requirements in [[plates]] to create an adapter plate. | |||
* cage the part | * cage the part | ||
<gallery> | <gallery> | ||
Latest revision as of 22:50, 7 November 2021
Technique: Odd parts first
| Reusability | Reversible |
|---|---|
| Designers: | Timothy Schmidt |
| Tools: | Wrenches |
| Parts: | Frames, Nuts, Bolts, End caps, Washers, Plates |
| Techniques: | Bolting |
Introduction
Most projects require at least one part which doesn't conform easily to the grids. This part is often central to the purpose of the project.
Challenges
Unique parts may not have easy mounting points or compatible hole patterns. Adapting them to the grids can be a challenge.
Approaches
- offset a frame with stacked washers to match an existing hole pattern
- drill holes matching your unique mounting requirements in plates to create an adapter plate.
- cage the part
