Wheels and axles: Difference between revisions
From
Line 33: | Line 33: | ||
==9 inch Ford bolt-on rear axle== | ==9 inch Ford bolt-on rear axle== | ||
* housing | |||
* third member | |||
* pinion yoke | |||
* gearset | |||
* axles | |||
* bearings | |||
=References= | =References= |
Revision as of 16:49, 8 May 2022
Technique: Wheels and axles
Reusability | Reversible |
---|---|
Designers: | Phil Jergenson |
Tools: | Wrenches |
Parts: | Frames, Nuts, Bolts, End caps, Axial bearings, Keyed shafts, Keys, Shaft collars, Wheel hubs, Wheels |
Techniques: | Tri joints |
Introduction
A beam axle, rigid axle or solid axle is a dependent suspension design, in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically they have also been used as front axles in four-wheel-drive vehicles. In most automobiles, beam axles have been replaced with front and rear independent suspensions.
Challenges
Approaches
Modular go kart drive
Integrated transaxle
9 inch Ford bolt-on rear axle
- housing
- third member
- pinion yoke
- gearset
- axles
- bearings