Wheels and axles: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 13: | Line 13: | ||
|files = | |files = | ||
|suppliers = | |suppliers = | ||
|reversible = true | |||
}} | }} | ||
Revision as of 10:03, 25 September 2021
Technique: Wheels and axles
Reusability | Reversible |
---|---|
Designers: | Phil Jergenson |
Tools: | Wrenches |
Parts: | Frames, Nuts, Bolts, End caps, Axial bearings, Keyed shafts, Keys, Shaft collars, Wheel hubs, Wheels |
Techniques: | Tri joints |
Introduction
A beam axle, rigid axle or solid axle is a dependent suspension design, in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically they have also been used as front axles in four-wheel-drive vehicles. In most automobiles, beam axles have been replaced with front and rear independent suspensions.