Warping boards: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 1: | Line 1: | ||
{{Projects infobox | {{Projects infobox | ||
|image = | |image = | ||
| | |designers = | ||
|date = | |date = | ||
|vitamins = | |vitamins = |
Revision as of 17:40, 18 September 2021
Project: Warping boards
Tools: | Wrenches |
---|---|
Parts: | Frames, Nuts, Bolts, End caps |
Techniques: | Tri joints, Shelf joints |
Introduction
Warping boards come in a variety of shapes, from the two nearest door handles to a board with pegs on it, or a device called a warping mill that looks similar to a swift. Warping the loom, mean threading each end through an eye in a heddle, and then sleying it through the reed. The warp is set (verb) at X ends per inch. It then has a sett (noun) of X ends per inch. The weft is measured in picks per inch.