Warping boards: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 9: | Line 9: | ||
|tools = [[Wrenches]] | |tools = [[Wrenches]] | ||
|parts = [[Frames]], [[Nuts]], [[Bolts]], [[End caps]] | |parts = [[Frames]], [[Nuts]], [[Bolts]], [[End caps]] | ||
|techniques = | |techniques = [[Tri joints]], [[Shelf joints]] | ||
|stl = | |stl = | ||
|git = | |git = |
Revision as of 19:23, 14 August 2021
Project: Warping boards
Tools: | Wrenches |
---|---|
Parts: | Frames, Nuts, Bolts, End caps |
Techniques: | Tri joints, Shelf joints |
Introduction
Warping boards come in a variety of shapes, from the two nearest door handles to a board with pegs on it, or a device called a warping mill that looks similar to a swift. Warping the loom, mean threading each end through an eye in a heddle, and then sleying it through the reed. The warp is set (verb) at X ends per inch. It then has a sett (noun) of X ends per inch. The weft is measured in picks per inch.