Vitamins: Difference between revisions
No edit summary |
No edit summary |
||
Line 1: | Line 1: | ||
Vitamin? | Vitamin? | ||
Replimat is intended to evolve to | Replimat is intended to evolve to make most of it's own parts. See [[Development Roadmap]]. However, there are a few parts which it won't be able to make... at least for now. | ||
See [[Development Roadmap]]. However, there are a few parts which it won't be able to make... at least for now. | |||
Replimat inherits the term vitamin from the [http://www.reprap.org RepRap project], a vitamin (also called an "imported part" or "non-printed part") is anything that you need to make Replimat, which Replimat cannot itself make. | Replimat inherits the term vitamin from the [http://www.reprap.org RepRap project], a vitamin (also called an "imported part" or "non-printed part") is anything that you need to make Replimat, which Replimat cannot itself make. |
Revision as of 20:50, 6 March 2020
Vitamin?
Replimat is intended to evolve to make most of it's own parts. See Development Roadmap. However, there are a few parts which it won't be able to make... at least for now.
Replimat inherits the term vitamin from the RepRap project, a vitamin (also called an "imported part" or "non-printed part") is anything that you need to make Replimat, which Replimat cannot itself make.
Currently, This list includes the following: Simple List of Non-Printed Parts
Fasteners Platforms
Grease Standard electronic chips such as microcontrollers and optical sensors Standard electrical wiring, USB connectors, LEDs and other electronics components, etc. Standard electrical PCBs -- at least until we have a breakthrough in Automated Circuitry Making Motors (Stepper, Servo, and DC alike) Power Supply Bolts -- though these can be reduced in count with design accomodations. (one RepRap design doesn't have any nuts or bolts or threaded rod). Ø8 mm steel rods (smooth rods and threaded rods)
Beyond that, all of the structural and mechanical parts should eventually be printable with FDM Rapid Prototyping technology. Except perhaps the hand that assembles it... for now anyway.
Initially we were under the impression that, in order for everyone that wants one to have a RepRap, we needed to design "the" RepRap from "components that are available worldwide". More recently some researchers have been experimenting with the idea that maybe it would be better (lower cost, stronger, etc.) to have several different RepRap designs to adapt to whatever local materials are available --
bamboo where available (Bamboo Printer, etc.) plywood and SAE components in North America (Paul Bunyan, SAE Mendel, SAE Prusa Mendel, etc.) steel and aluminum in Australia ice in Antarctica (IceRap) etc.