Plates: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 5: | Line 5: | ||
Create mounting plates from flat material, which contain the Replimat hole pattern, and a mounting pattern for an associated part. | Create mounting plates from flat material, which contain the Replimat hole pattern, and a mounting pattern for an associated part. | ||
=Tools= | |||
=Parts= | |||
==Corner plates== | ==Corner plates== | ||
Line 20: | Line 23: | ||
* 5x10 | * 5x10 | ||
* 5x1 | * 5x1 | ||
=Development targets= | |||
=Resources= | |||
[[Category: Parts]] | [[Category: Parts]] |
Revision as of 04:18, 2 July 2020
Challenge
Many parts do not match the Replimat hole pattern.
Approach
Create mounting plates from flat material, which contain the Replimat hole pattern, and a mounting pattern for an associated part.
Tools
Parts
Corner plates
T plates
Electronics mounting plates
-
Bitbeam-arduino-plate
-
Bitbeam-arduino-plate
-
Bitbeam-raspberry-pi-plate
-
Bitbeam-raspberry-pi-plate
Padded plates
- 5x10
- 5x1