Desks: Difference between revisions
From
No edit summary |
No edit summary |
||
Line 22: | Line 22: | ||
=Approaches= | =Approaches= | ||
<youtube>LM4CgXonxqw</youtube> | |||
[[File:Drafting-table-tim~20191021-183714.png|thumb|I designed this drafting table at Summit Station in Willits, CA. It uses no more parts than a flat desk of similar construction, but offers adjustable height and tilt, and a pen rest. It makes use of the [[shelf joint]] discovered by [[Joy Livingwell]]. I used Phil and RJ Jergenson's Gridbeam system, which favored frame lengths of 1ft, 2ft, 3ft, and so on. And allowed odd lengths. Consequently, the vertical beam has 32 holes. --[[User:Tim]]]] | [[File:Drafting-table-tim~20191021-183714.png|thumb|I designed this drafting table at Summit Station in Willits, CA. It uses no more parts than a flat desk of similar construction, but offers adjustable height and tilt, and a pen rest. It makes use of the [[shelf joint]] discovered by [[Joy Livingwell]]. I used Phil and RJ Jergenson's Gridbeam system, which favored frame lengths of 1ft, 2ft, 3ft, and so on. And allowed odd lengths. Consequently, the vertical beam has 32 holes. --[[User:Tim]]]] | ||
Line 51: | Line 53: | ||
* [https://www.opendesk.cc/ The OpenDesk Project] | * [https://www.opendesk.cc/ The OpenDesk Project] | ||
* [https://issuu.com/dosuno-design/docs/opentap_presskit_2.0 The OpenTap Project] | * [https://issuu.com/dosuno-design/docs/opentap_presskit_2.0 The OpenTap Project] | ||
Revision as of 21:19, 12 June 2021
Project: Desks
Tools: | Wrenches |
---|---|
Parts: | Frames, Nuts, Bolts, End caps, Plates |
Techniques: | Tri joints, Shelf joints |
Introduction
Challenges
Approaches
Adapter plates
- VESA mount
- ATX mount
Drafting table
-
Replimat drafting table rev1
-
Replimat drafting table rev1
Parts
Standing desk
-
Standing desk
-
Standing desk
Parts
Gaming desk
-
Gaming desk
-
Gaming desk