Search results

|techniques = [[Shelf joints]], [[Tri joints]], [[Wheels and axles]] ...ween parallel wheels at either the front or rear of the vehicle. The frame and drivetrain must be constructed to handle loads larger than those on an ordi ...

...ntiated by the system of linkages used to locate them, both longitudinally and transversely. Often, both functions are combined in a set of linkages. ...ried on the axle. Live-axle is simpler, but unsprung weight contributes to wheel bounce. ...

...lanar four-bar linkage. Spherical and spatial four-bar linkages also exist and are used in practice. ...Ural motorcycles used leading link forks on sidecar equipped motorcycles, and aftermarket leading link forks are often installed today on motorcycles whe ...

** nuts and bolts ** torsion axle or <s>half-axles</s> ...

...h anti-roll bars or other such mechanisms. The anti-roll bar ties the left and right suspension spring rates together but does not tie their motion togeth ...ent of load. Some active and semi-active suspensions maintain ride height, and therefore the camber, independent of load. In [[sports car]]s, optimal camb ...

2x front spindles and hubs and brakes 1" wheel hubs ...

|image = Axle.scad.png ...ys]] are fit into keyways to fix [[wheel hubs]], [[gears]], [[sprockets]], and other accessories to keyed shafts. ...

...ly, our parts are constructed from durable, reusable, renewable, recycled, and recyclable materials, making each part a multi-use carbon sink that contrib ...hallenges. Parts we haven't replicated yet are referred to as [[vitamins]] and can be sourced from existing processes or manufacturers. ...

...redirect a cable or rope, lift loads, and transmit power. The words sheave and pulley are sometimes used interchangeably. ...

...s the default handedness for screw threads. Therefore, most threaded parts and fasteners have right-handed threads. ** The left-hand grinding wheel on [[bench grinders]]. ...

...ension system that carries the hub for the wheel and attaches to the upper and lower control arms. ...[steering knuckles]] or "uprights". Although, the terms "steering knuckle" and "upright" are sometimes used interchangeably with "spindle", they refer to ...

...together directly, and differs from a pulley in that sprockets have teeth and pulleys are smooth except for timing pulleys used with toothed belts. ...of the rear wheel. Early automobiles were also largely driven by sprocket and chain mechanism, a practice largely copied from bicycles. ...

...otorcycle engine is the next logical option but that can be very expensive and wastes the existing powerplant (though I'm sure it could be put to other us .... Next, I looked at designs for geared, belt or chain driven transmissions and their parts costs. ...

|techniques = [[Bolting]], [[Tri joints]], [[Shelf joints]], [[Wheels and axles]], [[Independent suspensions]], [[Dependent suspensions]] ...pment, such as in the case of refuse trucks, fire trucks, concrete mixers, and suction excavators. In American English, a commercial vehicle without a tra ...

|image = Wheel-adapter.scad.png |parts = [[Shaft couplers]], [[Wheel adapter plates]] ...

...wheelbarrow by wind. The term "wheelbarrow" is made of two words: "wheel" and "barrow." "Barrow" is a derivation of the Old English "barew" which was a d ...the whole load. Use of wheelbarrows is common in the construction industry and in gardening. Typical capacity is approximately 100 litres (3.53 cubic feet ...

|image = Wheel-4-lug.scad.png ...under a load-bearing platform or case, the wheel turning on the horizontal axle makes it possible to transport heavy loads. ...

...ps]], [[Axial bearings]], [[Keyed shafts]], [[Keys]], [[Shaft collars]], [[Wheel hubs]], [[Wheels]] ...ve vehicles. In most automobiles, beam axles have been replaced with front and rear independent suspensions. ...