vacuforming_machines
Table of Contents
vacuforming machines
| Projects infobox | |
|---|---|
| image | |
| designers | |
| date | |
| vitamins | |
| materials | |
| transformations | |
| lifecycles | |
| tools | 3D printers |
| parts | Heaters, Frames, Nuts, Bolts, Plates, Vacuum pumps, Hoses, Valves, Hose clamps |
| techniques | |
| files | |
| suppliers | |
| git | |
Introduction
Vacuum forming is a simplified version of thermoforming, where a sheet of plastic is heated to a forming temperature, stretched onto a single-surface mold, and forced against the mold by a vacuum. This process can be used to form plastic into permanent objects such as turnpike signs and protective covers. Normally draft angles are present in the design of the mold (a recommended minimum of 3°) to ease removal of the formed plastic part from the mold.
Relatively deep parts can be formed if the formable sheet is mechanically or pneumatically stretched prior to bringing it into contact with the mold surface and applying the vacuum.
Challenges
Approaches
References
vacuforming_machines.txt · Last modified: by 127.0.0.1