fasten_loosely_until_assembled
Table of Contents
fasten loosely until assembled
| Techniques infobox | |
|---|---|
| image | |
| designers | |
| date | |
| vitamins | |
| materials | |
| transformations | |
| lifecycles | |
| parts | |
| techniques | |
| tools | Wrenches |
| git | |
| files | |
| suppliers | |
| reversible | true |
Introduction
Replimat frames automatically square and true themselves when assembled with tri joints. Replimat parts are manufactured to tight tolerances which result in a tight fit.
Challenges
Installing additional parts into projects which have already been tightened up can sometimes result in binding, tight fits, or hard to reach areas.
Approaches
When building a Replimat project, it's important to loosely bolt as many parts together as possible before tightening them all up. Start tightening with tri joints.
References
Original archived page — revision 8326, 2021-09-25T10:02:30+00:00, by Tim.
fasten_loosely_until_assembled.txt · Last modified: by 127.0.0.1